Oil Seal Vacuum Molding Machine | Other Rubber Machinery | Rubber Processing Machinery

Oil Seal Vacuum Molding Machine
Country:
Phone: 886-37-585326
Fax: 886-37-583363
E-mail: estw@eshinetw.com
Contact Person: Jack Lin
Share to: FacebookTwitterGoogle+
1. Vacuum system:
Uses MIT vacuum pump for high vacuity and low noise. Imported ball valves are used to offer high flow rate and fast vacuum extraction.
2. In / out-molds
With special Mold Frame devices , it is easy and convenient to set and operate.
3. Front ejector:
Using double-layer oil-less bearings, protected with a dust seal.
4. Monitoring design:
Overall monitoring on machine actions, pressure and flow rate, and warning messages and records.
5. Hydraulic circuit design:
Proportional Pressure and flow ratio system is designed for easily changing the pressure and speed setting.
6. Electrical control system:
6-1. Precise temperature controlled is achieved using PID calculations; temperature can be adjusted by the man-machine interface.
6-2. The module saving function includes temperature, pressure/ flow rate, time and function settings.
6-3. Heating system: using SSR solid relay with fast heat-up without exceeding the limit.
6-4. Mold calibration: slow mode calibration function is provided. To calibration the mold; simply press up/down key to complete the mold position setting.

TYPE
100 TON
Stroke (mm) 120
Working table (mm) 335x380
Mold frame dimensions (mm) 380x382
Piston diameter (mm) 250
Electrical heater (KW) 7.2
Motor (HP) 7.5
Vacuum motor (HP)
3
Total power (KW) 15
Mold opening method 2RT: Front Ejector to pull upper mold
3RT: 2RT With a ejector plate