Hot Runner System

slider1

Single Valve Gate Hot Runner System

Category : Molds and Dies

Dual-cylinder, powerful for gate seal. Nice gate mark. All in one, easy to install. Customize for your need....Details

Hot Runner System - Valve Gate- VG Type

Category : Molds and Dies

● Good & smooth gate vestige part surface but bad color change ability. ● Used for vehicles such as bumpers, car doors, car light moldings, food containers and products that require multi-shot...Details

Hot Runner System - Open Gate - LC Type

Category : Molds and Dies

● Excellent material flow ability and good color changeability. ● Good thermo conductivity, the open tip avoids the gate freeze up. ● Eliminates flow lines flow lines from nozzle. ● minimum mark. ...Details

OPEN GATE-ANPR

Category : Molds and Dies

This nozzle only has slight protruded vestige and very suitable for no flow mark required parts(transparent parts). Due to the contactless design of nozzle bushing, there is no bushing mark on...Details

OPEN GATE-ANPT

Category : Molds and Dies

The most used nozzle. There is a torpedo inside the nozzle to have a circularity gate and guide the melt along the torpedo to flow into the cavity, and therefore can reduce the production of cool...Details

OPEN GATE-NL ANPT

Category : Molds and Dies

There is a torpedo inside the nozzle to have a circularity gate and guide the melt along the torpedo to flow into the cavity, and therefore can reduce the production of cool plug. This series is...Details

VALVE GATE-NL SVDP

Category : Molds and Dies

Pneumatically shut-off nozzle can create a flawless gate with no drooling and no stringing. Gate only leaves a small witness ring. The large gate openings are possible. This makes processing at...Details

VALVE GATE-SVDT

Category : Molds and Dies

For the valve pin bushing is integrated with the nozzle, the structure of manifold become very simple, and therefore this series is most suitable for the multi-cavity application. There is a pin in...Details

VALVE GATE-AVMT

Category : Molds and Dies

Suitable for large-scale parts or complex shape parts. There is a pin in the nozzle and drive by pneumatic or hydraulic to open or close the nozzle gate. When the valve pin open / close can control...Details

Hot Runner System

Category : Molds and Dies

Hot runner system is an advanced injection molding system. Nozzle and manifold block are heated under temperature control of the Temp-controller, so that the plastics from the nozzle of injection...Details