Classification : High-Speed Hot Press Molding Machine
Country:
Phone: 886-37-585326
Fax: 886-37-583363
Contact Person: Jack Lin
1. In/Out molds:
Designed with special isolating devices to prevent wearing of the heat plate and the in/out-mold plate.
2. Front ejector:
Using double-layer oil-less bearings, protected with a dust seal.
3. Monitoring design:
Overall monitoring on machine actions, pressure and flow rate, and warning messages and records.
4. Hydraulic circuit design:
Fully proportional hydraulic system, pressure and speeds can be easily adjusted.
5. Electrical control system:
5-1. Precise temperature controlled is using PID calculations, temperature can be adjusted by the man-machine interface.
5-2. The module saving function includes temperature, pressure/ flow rate, time and function settings.
5-3. Heating system: using SSR solid relay with fast heat-up without exceeding the limit.
5-4. Mold calibration: slow mode calibration function is provided. To calibrate the mold, simply press up/down key to complete the mold position setting.
Designed with special isolating devices to prevent wearing of the heat plate and the in/out-mold plate.
2. Front ejector:
Using double-layer oil-less bearings, protected with a dust seal.
3. Monitoring design:
Overall monitoring on machine actions, pressure and flow rate, and warning messages and records.
4. Hydraulic circuit design:
Fully proportional hydraulic system, pressure and speeds can be easily adjusted.
5. Electrical control system:
5-1. Precise temperature controlled is using PID calculations, temperature can be adjusted by the man-machine interface.
5-2. The module saving function includes temperature, pressure/ flow rate, time and function settings.
5-3. Heating system: using SSR solid relay with fast heat-up without exceeding the limit.
5-4. Mold calibration: slow mode calibration function is provided. To calibrate the mold, simply press up/down key to complete the mold position setting.
TyPE | 100 TON | 150 TON | 200 TON | 250 TON | 300 TON | 500 TON |
Stroke (mm) | 250 | 250 | 250 | 250 | 250 | 300 |
Upper heater Plate (mm) | 400*400 | 440*440 | 510*510 | 600*600 | 600*600 | 850*850 |
Lower heater Plater (mm) | 445*450 | 500*500 | 540*560 | 650*600 | 650*650 | 850*850 |
Mold in-out plate (mm) | 445*500 | 550*560 | 540*570 | 650*650 | 650*680 | 855*880 |
Piston diameter (mm) | 250 | 300 | 350 | 400 | 450 | 560 |
Electrical heater (KW) | 22 | 34 | 34 | 34 | ||
Motor (HP) | 15HP | 15HP | 15HP | 15HP | 10HP*2 | 10HP*2 |
-single | -single | -single | -single | -twin | -twin | |
Total power (KW) | 40 | 48 | 52 | 52 | ||
Size | ||||||
Mold opening Method | 0RT: up/down 3RT: middle mold | |||||
1RT: in/out 4RT:Top mol | ||||||
2RT: front ejector |